Thermostat Display (AN20100) Hard Reset
|
Step |
Notes |
---|---|---|
1 |
Remove the Thermostat Display from the wall |
Steps to remove:
|
2 |
Remove the batteries and then reinstall them |
|
3 |
Lay the Thermostat Display down on a flat surface with the display side facing up |
|
4 |
Confirm the Anacove logo is displayed on the screen |
|
5 |
Wait for "OFF", "COOL", "HEAT", or "FAN" to be displayed on the screen |
|
7 |
Mount the Thermostat Display to the wall mount |
Start with the lower fingers of the wall mount being inserted. Then while pressing the bottom to hold the unit in place roll the pressure to the top with your other hand, and the unit will click into place. If the unit is installed roughly the batteries might be dislodged and the Anacove logo will be displayed and never show the room temperature. If this happens the unit needs to be removed form the wall and the batteries checked again |
8 |
Press the power button a few times so that the unit can be seen to switch from OFF to ON |
|
9 |
Press the FAN button and confirm the fan turns on at the PTAC |
|
10 |
If the room is unrented, turn the Thermostat Display off If the room rented, leave the Thermostat Display on |
If you happen to leave the Thermostat Display on in a room that is unrented, it will automatically turn off after 30 minutes |