Islandaire EZ42xxxxxxxxxxx & EZDRxxxxxxxxxxx PTAC Configuration Guide
***If the unit has a rotary/mechanical dial for the temperature control it is not compatible to have a remote thermostat installed. Anacove’s Screw Terminal Wiring Harness (AN40400) is connected to the Islandaire remote thermostat pigtail by connecting the wires with wire nuts***
|
Remote Thermostat Interface |
Remote Thermostat Interface Image |
|
Pin Header |
 |
EZ42xxxxxxxxxxx & EZDRxxxxxxxxxxx Remote Thermostat Enable:
|
Step |
Image |
|
|
1 |
Unplug the PTAC |
|
|
2 |
There are two sets of dip switches on the control board (one with 6 switches and one with 2). On the one with 2 dip switches, switch dip switch 1 into the ON position |
|
|
3 |
Plug the PTAC back in |
AN40400 - Screw terminal PTAC wiring harness color coding guide:
***Unused Anacove Wiring Harness wires should be removed from the Wiring Harness. Cut the wire off approximately 1/2" from the HVAC Controller end of the harness***
|
Anacove Wire Color |
EZ42xxxxxxxxxxx & EZDRxxxxxxxxxxx Remote Thermostat Interface Wire Color |
|
Red |
R/RED |
| Black |
C/BLACK |
| White |
W/WHITE |
| Yellow |
Y/YELLOW |
| Green |
GL/ORANGE |
| Brown |
GH/GREEN |
| Blue |
B/BLUE |
| Orange |
Not Used |
| Islandaire PTAC HVAC Controller Gateway Mounting Placement |
 |