Hotpoint AHES & AHHS PTAC Configuration Guide

***This PTAC unit requires a 24V Interface Kit be installed to it in order to be able to have a thermostat connected and control the unit. Refer to the below table to determine the appropriate Interface Kit for the specific model that you have.***

Remote Thermostat Interface	Remote Thermostat Interface Image
Screw Terminal

AHES & AHHS Remote Thermostat Enable:

	Step	Image
1	Unplug the PTAC
2	Move dip switch S1 into UP (ON) position
3	Plug the PTAC back in

AN40400 - Screw terminal PTAC wiring harness color coding guide:

***Unused Anacove Wiring Harness wires should be removed from the Wiring Harness. Cut the wire off approximately 1/2" from the HVAC Controller end of the harness***