GE AZ41E & AZ61H PTAC Configuration Guide
|
Remote Thermostat Interface |
Remote Thermostat Interface Image |
|
Screw Terminal |
 |
GE AZ41E & AZ61H Series Remote Thermostat Enable:
|
Steps |
Image |
|
|
1 |
Turn the unit off at the control panel. The unit needs power but the On/Off button should be off |
|
|
2 |
Lift the front cover off and press the red Aux Set button |
 |
|
3 |
Press the mode button until the first digit of the LED display reads "6" |
 |
|
4 |
Press the + button until the digit next to the 6 is an "n" |
 |
|
5 |
Press the red Aux Set button to save the Use Wall Thermostat setting |
|
|
6 |
The backlit display should read "Use Wall Thermostat" to confirm the sequence was completed successfully |
 |
AN40400 - Screw terminal PTAC wiring harness color coding guide:
***Unused Anacove Wiring Harness wires should be removed from the Wiring Harness. Cut the wire off approximately 1/2" from the HVAC Controller end of the harness***
|
Anacove Wire Color |
AZ41E & AZ61H Remote Thermostat Interface |
|
Red |
R |
|
Black |
C |
|
White |
W |
|
Yellow |
Y |
|
Green |
GL |
|
Brown |
GH |
|
Blue |
B |
|
Orange |
Not Used |