Screenshot 2023-03-01 145210

Friedrich VHAxxxxxxRTP-x VTAC Configuration Guide

 

***The HVAC Controller Gateway should always be mounted as close to the return of the VTAC as possible***

***These units require the installation of an additional 24VAC transformer be installed in order to properly power the Anacove HVAC Controller Gateway. The transformer should be an appropriate transformer for either the 230/208V or 265V that the VTAC is. Reference the below section about wiring for how to wire these up***

Remote Thermostat Interface

Remote Thermostat Interface Image

Screw Terminal

 

 

VHAxxxxxRTP-x Series Remote Thermostat Enable:

 

Steps

1

There are no configuration settings to be made as the VTAC is always in remote thermostat mode

 

AN40400 - Screw Terminal Wiring Harness color coding guide:

***Unused Anacove Wiring Harness wires should be removed from the Wiring Harness. Cut the wire off approximately 1/2" from the HVAC Controller end of the harness***

Anacove Wire Color

VHAxxxxxRTP-x Remote Thermostat Interface

24 V AC Transformer Wire Color

Red (connect via wire/lever nut)

N/A

Red (connect via wire/lever nut)

Black (connect via wire/lever nut)

C (connect via wire/lever nut)

Black (connect via wire/lever nut)

White

W

N/A

Yellow

Y

N/A

Green

GL

N/A

Brown

GH

N/A

Blue

B

N/A

Orange (not used)

N/A

N/A