Friedrich PVExxx & PVHxxx PTAC Configuration Guide
|
Remote Thermostat Interface |
Remote Thermostat Interface Image |
|
Screw Terminal |
|
PVExxx & PVHxxx Series Remote Thermostat Enable:
|
Steps |
|
|
1 |
Turn the unit off at the user controls. The unit needs power but the power/on/off button should be off |
|
2 |
Hold the "Cool" and "Low" buttons at the same time for 5 seconds until the display reads "d0" |
|
3 |
Press the "Cool" button until the display reads "d1" |
|
4 |
Press the "▲" button until the display reads "r" |
|
5 |
Press the power/on/off button to set the mode |
|
6 |
Power down the unit by removing it's power source |
|
7 |
Move dip switch SW3-1 into the ON/CON position |
|
8 |
Move dip switch SW3-2 in the OFF/CYC position |
|
9 |
Power the unit back on by restoring it's power source |
AN40400 - Screw terminal PTAC wiring harness color coding guide:
***Unused Anacove Wiring Harness wires should be removed from the Wiring Harness. Cut the wire off approximately 1/2" from the HVAC Controller end of the harness***
|
Anacove Wire Color |
PVExxx & PVHxxx Remote Thermostat Interface |
|
Red |
R |
|
Black |
C |
|
White |
W |
|
Yellow |
Y |
|
Green |
GL |
|
Brown |
GH |
|
Blue |
B |
|
Orange |
Not Used |
|
Friedrich PTAC HVAC Controller Gateway Mounting Placement |
 |