Climate Master TC VTAC Configuration Guide
***In order to connect the Anacove HVAC Controller Gateway to this unit you must use a power relay. Anacove suggests the American Zettler AZ2280 model but if you choose to use another power relay make sure it has the same configuration as noted in the power relay wiring diagram image below. ***
|
Remote Thermostat Interface |
Remote Thermostat Interface & Power Relay Images |
|
Screw Terminal - Use Anacove Screw Terminal Wiring Harness For Thermostat Wired Adaptor (AN41900) |
Remote Thermostat Interface
Power Relay Wiring Diagram
|
TC Series Remote Thermostat Enable:
|
Step |
|
|
1 |
There are no configuration settings to be made as the VTAC is always in remote thermostat mode |
AN40400 - Screw Terminal Wiring Harness color coding guide:
***Unused Anacove Wiring Harness wires should be removed from the Wiring Harness. Cut the wire off approximately 1/2" from the HVAC Controller end of the harness***
|
Anacove Wire Color |
TC Remote Thermostat Interface & Power Relay |
|
Red |
R & Relay 4 |
|
Black |
C & Relay 5 |
|
White |
Not Used |
|
Yellow |
Relay 1 |
|
Green |
G |
|
Brown |
Not Used |
|
Blue |
Not Used |
|
Orange |
O |
|
N/A |
VTAC Y to Relay 2 |